BS EN 488:2015 PDF

District heating pipes. Preinsulated bonded pipe systems for directly buried hot water networks. Steel valve assembly for steel service pipes, polyurethane thermal insulation and outer casing of polyethylene

Название (английский):

BS EN 488:2015

Статус документа:: Отменён
Формат:: Электронный (PDF)
Дата публикации:: 30 ноября 2015 г.
ICS:: 23.060.01
SKU:: BS EN 488:2015

Тип поставки:

Full version50 €Read online 24h10 €Read online 72h15 €

Язык документа:

ruen

Срок поставки:1 раб. дн. (перевод)

Цена:50 €

Abstract

1 Scope This European Standard specifies requirements and test methods for valves of prefabricated thermally insulated valve assemblies comprising a steel valve , rigid polyurethane foam insulation and an outer casing of polyethylene for use in directly buried hot water networks with pre-insulated pipe assemblies in accordance with EN 253. This European Standard applies only to factory made prefabricated insulated valve assemblies for continuous operation with hot water at various temperatures in accordance with EN 253:2009+A2:2015, Clause 1, and the valve assemblies with a maximum operation pressure of 25 bar. For higher pressures, additional demands apply.

NOTE For this application, the following valve types are commonly used: ball valves , gate valves , and butterfly valves .

This European Standard does not include calculation rules for loads and stresses. These depend on the configuration of the system as it is installed. The design and installation rules are given in EN 13941.

BS EN 488:2015 PDF

Abstract

Похожие стандарты

Abstract

Похожие стандарты

Aerospace series. Circuit breakers. Test methods. Performance with a locked tripping system.

Information technology. Electronic discovery. Technical readiness.

Test conditions for machining centres. Accuracy and repeatability of positioning of linear and rotary axes.

Aerospace series. Acrylonitrile-butadiene rubber (NBR). Low temperature resistant. Hardness 60 IRHD.

Mountaineering equipment. Frictional anchors. Safety requirements and test methods.

Health Informatics. General purpose information components. Non-clinical.

Ambient air. Standard method for the measurement of the concentration of carbon monoxide by non-dispersive in…

Information Technology. BIOS Protection Guidelines.