This site uses cookies and visit counters for operation and statistics. Privacy policy
Found: 9 942
Country: 🌐 International standards
Fibre optic connector interfaces - Part 9: Type DS connector family
Recommendations for renewable energy and hybrid systems for rural electrification - Part 5: Protection against electrical hazards
Fibre optic interconnecting devices and passive components - Conditions for testing the protection against dust and water ingress of passive optical protective housings and hardened fibre optic connectors (IP5X, IPX4, I…
Fuel cell technologies - Part 6-401: Micro fuel cell power systems - Power and data interchangeability - Performance test methods for laptop computer
Coaxial communication cables - Part 1-215: Environmental test methods - High temperature cable ageing
Organic light emitting diode (OLED) displays - Part 6-1: Measuring methods of optical and electro-optical parameters
Metallic communication cable test methods - Part 4-10: Electromagnetic compatibility (EMC) - Transfer impedance and screening attenuation of feed-throughs and electromagnetic gaskets - Double coaxial test method
Insulating liquids - Determination of the dielectric dissipation factor by measurement of the conductance and capacitance - Test method
Mechanical structures for electronic equipment - Tests for IEC 60917 and 60297 - Part 2: Seismic tests for cabinets and racks
Multicore and symmetrical pair/quad cables for digital communications - Part 5: Symmetrical pair/quad cables with transmission characteristics up to 1 000 MHz - Horizontal floor wiring - Sectional specification
Rules for steam turbine thermal acceptance tests - Part 3: Thermal performance verification tests of retrofitted steam turbines
Fibre optic communication system design guidelines - Part 16: Coherent receivers and transmitters with high-speed digital signal processing
Connectors for electronic equipment - Tests and measurements - Part 11-3: Climatic tests - Test 11c: Damp heat, steady state
Radio frequency and coaxial cable assemblies - Part 3-1: Blank detail specification for semi-flexible coaxial cable assemblies
Low voltage surge protective devices - Part 21: Surge protective devices connected to telecommunications and signalling networks - Requirements and test methods
Metallic cables and other passive components - Test methods - Part 4-17: Electromagnetic compatibility (EMC) - Reduction Factor
Fire hazard testing - Part 7-3: Toxicity of fire effluent - Use and interpretation of test results
Guidance on colour coding of optical fibre cables
Household and similar electrical appliances - Safety - Part 2-4: Particular requirements for spin extractors
Measurement of cavitation noise in ultrasonic baths and ultrasonic reactors
