This site uses cookies and visit counters for operation and statistics. Privacy policy
Found: 9 942
Country: 🌐 International standards
Fixed capacitors for use in electronic equipment - Part 16-1: Blank detail specification: Fixed metallized polypropylene film dielectric d.c. capacitors - Assessment levels E and EZ
Potentiometers for use in electronic equipment - Part 5: Sectional specification - Single-turn rotary low-power wirewound and non-wirewound potentiometers
Optical fibre amplifiers - Basic specification - Part 2-3: Test methods for optical power parameters - Optical power meter
Broadcast video tape recorders - Methods of measurement - Part 4: Analogue audio performance measurements
Insulation co-ordination - Part 2: Application guidelines
Low-frequency cables with polyolefin insulation and moisture barrier polyolefin sheath
Power transformers - Part 8: Application guide
Fixed inductors for electromagnetic interference suppression - Part 2-1: Blank detail specification - Inductors for which safety tests are required
General safety requirements for residual current operated protective devices - Part 1: Residual current operated protective devices for DC systems
Radio-frequency connectors - Part 70: Sectional specification for series HD-BNC radio-frequency coaxial connectors - Characteristic Impedance 75 Ω
Fibre optic interconnecting devices and passive components - Basic test and measurement procedures - Part 2-7: Tests - Bending moment
Connectors for electronic equipment - Tests and measurements - Part 15-6: Connector tests (mechanical) - Test 15f: Effectiveness of connector coupling devices
Cable networks for television signals, sound signals and interactive services - Part 2: Electromagnetic compatibility for equipment
Electric cables - Calculation of the current rating - Part 1-2: Current rating equations (100 % load factor) and calculations of losses - Sheath eddy current loss factors for two circuits in flat formation
Materials for printed boards and other interconnecting structures - Part 2-30: Reinforced base materials clad and unclad - Non-halogenated epoxide modified cyanate ester woven glass laminate of defined flammability (ver…
Graphical symbols for use on equipment - Part 1: Overview and application
Luminaires - Part 2-14: Particular requirements - Luminaires for cold cathode tubular discharge lamps (neon tubes) and similar equipment
Circuit boards and circuit board assemblies - Design and use - Part 6-2: Land pattern design - Description of land pattern for the most common surface mounted components (SMD)
Industrial communication networks - Fieldbus specifications - Part 5-28: Application layer service definition - Type 28 elements
Flexible insulating sleeving - Part 3: Specifications for indiviual types of sleeving - Sheet 272: Heat-shrinkable elastomer sleeving, flame retarded, fluid resistant, shrink ratio 2:1, thin wall