This site uses cookies and visit counters for operation and statistics. Privacy policy
Found: 9 942
Country: 🌐 International standards
Optical fibres - Part 1-1: Measurement methods and test procedures - General and guidance
Connectors for electronic equipment - Part 7-2: Detail specification for 8-way, unshielded, free and fixed connectors, for data transmissions with frequencies up to 100 MHz
Flexible insulating sleeving - Part 3: Specifications for individual types of sleeving - Sheet 271: Heat-shrinkable elastomer sleevings, flame retarded, fluid resistant, shrink ratio 2:1
Explosive atmospheres - Part 35-1: Caplights for use in mines susceptible to firedamp - General requirements - Construction and testing in relation to the risk of explosion
High-voltage direct current (HVDC) transmission - Vocabulary
Connectors for electronic equipment - Tests and measurements - Part 12-4: Soldering tests - Test 12d: Resistance to soldering heat, solder bath method
Semiconductor devices - Part 12-5: Optoelectronic devices - Blank detail specification for pin-photodiodes with/without pigtail, for fibre optic systems or subsystems
Dependability management - Part 3-7: Application guide - Reliability stress screening of electronic hardware
Helican-scan digital video cassette recording format using 12,65 mm magnetic tape and incorporating MPEG-4 compression - Type D-16 format
Specifications for particular types of winding wires - Part 0-7: General requirements - Fully insulated (FIW) zero-defect enamelled round copper wire
Low-voltage switchgear and controlgear - Part 7-4: Ancillary equipment - PCB terminal blocks for copper conductors
Medical electrical equipment - Part 2-30: Particular requirements for the safety, including essential performance, of automatic cycling non-invasive blood pressure monitoring equipment
Photovoltaic devices - Part 9: Classification of solar simulator characteristics
Tests on electric and optical fibre cables under fire conditions - Part 2-2: Test for vertical flame propagation for a single small insulated wire or cable - Procedure for diffusion flame
Electromechanical components for electronic equipment - Basic testing procedures and measuring methods - Part 19: Chemical resistance tests - Section 3: Test 19c - Fluid resistance
Radio frequency and coaxial cable assemblies - Part 4: Sectional specification for semi-rigid coaxial cable assemblies
Connectors for optical fibres and cables - Part 14-1: Detail specification for fibre optic connector type SC/PC standard terminated to multimode fibre type A1a, A1b
Tests on electric and optical fibre cables under fire conditions - Part 3-23: Test for vertical flame spread of vertically-mounted bunched wires or cables - Category B
Household and similar electrical appliances - Safety - Part 2-55: Particular requirements for electrical appliances for use with aquariums and garden ponds
Quartz crystal units of assessed quality - Part 2: Guidelines for the use