This site uses cookies and visit counters for operation and statistics. Privacy policy
Found: 8 955
Connecting devices - Electrical copper conductors - Safety requirements for screw-type and screwless-type clamping units - Part 1: General requirements and particular requirements for clamping units for conductors from…
Connectors for electronic equipment - Tests and measurements - Part 12-1: Soldering tests - Test 12a: Solderability, wetting, solder bath method
Oil-filled electrical equipment - Sampling of free gases and analysis of free and dissolved gases in mineral oils and other insulating liquids - Guidance
Connectors for optical fibres and cables - Part 14-10: Fibre optic pigtail or patch cord connector type SC-APC untuned 8° terminated on single mode fibre type B1 - Detail specification
Connectors for electronic equipment - Tests and measurements - Part 2-2: Electrical continuity and contact resistance tests - Test 2b: Contact resistance - Specified test current method
Optical fibres - Part 1-51: Measurement methods and test procedures - Dry heat (steady state) tests
Materials for printed boards and other interconnecting structures - Part 2-5: Reinforced base materials, clad and unclad - Brominated epoxide cellulose paper reinforced core/woven E-glass reinforced surfaces laminated s…
Connectors for electronic equipment - Part 7-1: Detail specification for 8-way, shielded, free and fixed connectors
Radiation protection instrumentation - Data format for radiation instruments used in the detection of illicit trafficking of radioactive materials
Quartz crystal controlled oscillators of assessed quality - Part 4-1: Blank detail specification - Capability approval
Tests on electric and optical fibre cables under fire conditions - Part 3-10: Test for vertical flame spread of vertically-mounted bunched wires or cables - Apparatus
Tests on electric and optical fibre cables under fire conditions - Part 3-21: Test for vertical flame spread of vertically-mounted bunched wires or cables - Category A F/R
Electrical installations in ships - Part 304: Equipment - Semiconductor converters
High-voltage fuses - Part 2: Expulsion fuses
Radio frequency connectors - Part 1-5: Electrical test methods - Rise time degradation
Optical amplifiers - Test methods - Part 4-1: Gain transient parameters - Two-wavelength method
Lead-acid traction batteries - Part 1: General requirements and methods of tests
Electromechanical equipment guidance for small hydroelectric installations
Aircraft batteries - Part 1: General test requirements and performance levels
Connectors for electronic equipment - Tests and measurements - Part 16-8: Mechanical tests on connections and terminations - Test 16h: Insulating grip effectiveness (crimped connections)