This site uses cookies and visit counters for operation and statistics. Privacy policy
Found: 9 942
Electrical installations in ships - Part 503: Special features - AC supply systems with voltages in the range of above 1 kV up to and including 36 kV
Automatic electrical controls - Part 1: General requirements
Methods of measurement for radio transmitters - Part 14: External intermodulation products caused by two or more transmitters using the same or adjacent antennas
Basic and safety principles for man-machine interface, marking and identification - Actuating principles
Solderless connections - Part 7: Spring clamp connections - General requirements, test methods and practical guidance
Integrated circuits - EMC evaluation of transceivers - Part 1: General conditions and definitions
Connectors for electronic equipment - Part 7-001: Cable outlet accessories - Blank detail specification
Semiconductor devices - Mechanical and climatic test methods - Part 4: Damp heat, steady state, highly accelerated stress test (HAST)
Industrial communication networks - Fieldbus specifications - Part 4-21: Data-link layer protocol specification - Type 21 elements
Fire hazard testing - Part 11-11: Test flames - Determination of the characteristic heat flux for ignition from a non-contacting flame source
Coaxial communication cables - Part 1-203: Environmental test methods - Test for water penetration of cable
Arc welding equipment - Part 3: Arc striking and stabilizing devices
Vulcanized fibre for electrical purposes - Part 1: Definitions and general requirements
Radiation protection instrumentation - Equipment for continuous monitoring of radioactivity in gaseous effluents - Part 2: Specific requirements for radioactive aerosol monitors including transuranic aerosols
Radio-frequency connectors - Part 10: Sectional specification for RF coaxial connectors with inner diameter of outer conductor 3 mm (0,12 in) with snap-on coupling - Characteristic impedance 50 Ω (Type SMB)
Tests on electric and optical fibre cables under fire conditions - Part 3-24: Test for vertical flame spread of vertically-mounted bunched wires or cables - Category C
Connectors for optical fibres and cables - Part 14-9: Fibre optic connector type SC-APC tuned 8° terminated on single mode fibre type B1 - Detail specification
Connectors for electronic equipment - Tests and measurements - Part 9-2: Endurance tests - Test 9b: Electrical load and temperature
Connectors for optical fibres and cables - Part 12: Sectional specification for fibre optic connector - Type OCCA-BU
Connectors for optical fibres and cables - Part 3: Sectional specification for fibre optic connector - Type CF03