This site uses cookies and visit counters for operation and statistics. Privacy policy
Found: 9 942
Multicore and symmetrical pair/quad cables for digital communications - Part 13: Symmetrical single pair cables with transmission characteristics up to 20 MHz - Horizontal floor wiring - Sectional specification
Fixed resistors for use in electronic equipment - Part 2-10: Blank detail specification: Low-power film resistors with leads for through-hole assembly on circuit boards (THT), for general electronic equipment, classific…
Semiconductor devices - Integrated circuits - part2-12: Digital integrated circuits - Blank detail specification for programmable logic devices (PLDs)
Electromagnetic compatibility (EMC) - Part 4-29: Testing and measurement techniques - Voltage dips, short interruptions and voltage variations on d.c. input power port immunity tests
Coaxial communication cables - Part 4: Sectional specification for radiating cables
Test methods for electrical materials, circuit boards and other interconnection structures and assemblies - Part 2-720: Detection of defects in interconnection structures by measurement of capacitance
Primary batteries — Part 3: Watch batteries
Connectors for electronic equipment - Part 7-82: Detail specification for 8-way, 12 contacts, shielded, free and fixed connectors, for data transmission with frequencies up to 2 000 MHz
Fibre optic interconnecting devices and passive components - Basic test and measurement procedures - Part 3-14: Examinations and measurements - Error and repeatability of the attenuation settings of a variable optical a…
Connectors for electronic equipment - Tests and measurements - Part 6-1: Dynamic stress tests - Test 6a: Acceleration, steady state
Ferrite cores - Guidelines on the limits of surface irregularities - Part 4: Ring-cores
Series capacitors for power systems - Part 3: Internal fuses
Connectors for optical fibres and cables - Part 14-3: Detail specification for fibre optic adaptor (simplex) type SC for single-mode fibre
Industrial electroheating equipment - Test methods for direct arc furnaces
Radio-frequency connectors - Part 64: Sectional specification - RF coaxial connectors with 0,8 mm inner diameter of outer conductor - Characteristic impedance 50 Ω (type 0,8)
Communication networks and systems for power utility automation - Part 80-5: Guideline for mapping information between IEC 61850 and IEC 61158-15
Industrial communication networks - Fieldbus specifications - Part 3-28: Data-link layer service definition - Type 28 elements
High-voltage test techniques – Charge-based measurement of partial discharges
Fire hazard testing - Part 1-1: Guidance for assessing the fire hazard of electrotechnical products - General guidelines
Optical fibre cables - Part 1-218: Generic specification - Basic optical cable test procedures - Environmental test methods - Mid-span temperature cycling test for exposed optical cable elements, method F18