This site uses cookies and visit counters for operation and statistics. Privacy policy
Found: 8 955
Connectors for electronic equipment - Tests and measurements - Part 27-100: Signal integrity tests up to 500 MHz on 60603-7 series connectors - Tests 27a to 27g
Safety requirements for electrical equipment for measurement, control, and laboratory use - Part 2-012: Particular requirements for climatic and environmental testing and other temperature conditioning equipment
Test procedure for the determination of the temperature index of enamelled and tape wrapped winding wires
Multicore and symmetrical pair/quad cables for digital communications - Part 13: Symmetrical single pair cables with transmission characteristics up to 20 MHz - Horizontal floor wiring - Sectional specification
Fixed resistors for use in electronic equipment - Part 2-10: Blank detail specification: Low-power film resistors with leads for through-hole assembly on circuit boards (THT), for general electronic equipment, classific…
Semiconductor devices - Integrated circuits - part2-12: Digital integrated circuits - Blank detail specification for programmable logic devices (PLDs)
Electromagnetic compatibility (EMC) - Part 4-29: Testing and measurement techniques - Voltage dips, short interruptions and voltage variations on d.c. input power port immunity tests
Coaxial communication cables - Part 4: Sectional specification for radiating cables
Test methods for electrical materials, circuit boards and other interconnection structures and assemblies - Part 2-720: Detection of defects in interconnection structures by measurement of capacitance
Primary batteries — Part 3: Watch batteries
Connectors for electronic equipment - Part 7-82: Detail specification for 8-way, 12 contacts, shielded, free and fixed connectors, for data transmission with frequencies up to 2 000 MHz
Fibre optic interconnecting devices and passive components - Basic test and measurement procedures - Part 3-14: Examinations and measurements - Error and repeatability of the attenuation settings of a variable optical a…
Connectors for electronic equipment - Tests and measurements - Part 6-1: Dynamic stress tests - Test 6a: Acceleration, steady state
Series capacitors for power systems - Part 3: Internal fuses
Connectors for optical fibres and cables - Part 14-3: Detail specification for fibre optic adaptor (simplex) type SC for single-mode fibre
Industrial electroheating equipment - Test methods for direct arc furnaces
Radio-frequency connectors - Part 64: Sectional specification - RF coaxial connectors with 0,8 mm inner diameter of outer conductor - Characteristic impedance 50 Ω (type 0,8)
Communication networks and systems for power utility automation - Part 80-5: Guideline for mapping information between IEC 61850 and IEC 61158-15
Industrial communication networks - Fieldbus specifications - Part 3-28: Data-link layer service definition - Type 28 elements
High-voltage test techniques – Charge-based measurement of partial discharges