This site uses cookies and visit counters for operation and statistics. Privacy policy
Found: 8 955
Radio frequency and coaxial cable assemblies - Part 2-5: Detail specification for cable assemblies for radio and TV receivers - Frequency range 0 MHz to 1 000 MHz, IEC 61169-2 connectors
Mechanical standardization of semiconductor devices - Part 6-1: General rules for the preparation of outline drawings of surface mounted semiconductor device packages - Design guide for gull-wing lead terminals
Low-voltage switchgear and controlgear - Part 9-2: Active arc-fault mitigation systems - Optical-based internal arc-detection and mitigation devices
Time and control code
Coatings for loaded printed wire boards (conformal coatings) - Part 2: Methods of test
Optical fibres - Part 1-49: Measurement methods and test procedures - Differential mode delay
Power transformers - Part 22-1: Power transformer and reactor fittings - Protective devices
Connecting devices for low-voltage circuits for household and similar purposes - Part 2-3: Particular requirements for connecting devices as separate entities with insulation-piercing clamping units
Fixed capacitors for use in electronic equipment - Part 23: Sectional specification - Fixed metallized polyethylene naphthalate film dielectric surface mount DC capacitors
Electrical installations in ships - Part 503: Special features - AC supply systems with voltages in the range of above 1 kV up to and including 36 kV
Automatic electrical controls - Part 1: General requirements
Methods of measurement for radio transmitters - Part 14: External intermodulation products caused by two or more transmitters using the same or adjacent antennas
Basic and safety principles for man-machine interface, marking and identification - Actuating principles
Solderless connections - Part 7: Spring clamp connections - General requirements, test methods and practical guidance
Integrated circuits - EMC evaluation of transceivers - Part 1: General conditions and definitions
Connectors for electronic equipment - Part 7-001: Cable outlet accessories - Blank detail specification
Semiconductor devices - Mechanical and climatic test methods - Part 4: Damp heat, steady state, highly accelerated stress test (HAST)
Industrial communication networks - Fieldbus specifications - Part 4-21: Data-link layer protocol specification - Type 21 elements
Fire hazard testing - Part 11-11: Test flames - Determination of the characteristic heat flux for ignition from a non-contacting flame source
Coaxial communication cables - Part 1-203: Environmental test methods - Test for water penetration of cable