This site uses cookies and visit counters for operation and statistics. Privacy policy
Found: 9 942
Coaxial communication cables - Part 5: Sectional specification for CATV trunk and distribution cables
Insulators for overhead lines with a nominal voltage above 1000 V - Part 1: Ceramic or glass insulator units for a.c. systems - Definitions, test methods and acceptance criteria
Pressure-sensitive adhesive tapes for electrical purposes - Part 3: Specifications for individual materials - Sheet 16: Polyester film/glass filament combinations with pressure-sensitive adhesive
Mechanical structures for electronic equipment - Dimensions of mechanical structures of the 482,6 mm (19 in) series - Part 3-104: Connector dependent interface dimensions of subracks and plug-in units
Radio-frequency connectors - Part 16: Sectional specification - RF coaxial connectors with inner diameter of outer conductor 7 mm (0,276 in) with screw coupling - Characteristics impedance 50 ohms (75 ohms) (type N)
Specifications for particular types of winding wires - Part 61: Polyester glass-fibre wound, resin or varnish impregnated, bare or enamelled rectangular copper wire, temperature index 180
Materials for interconnection structures - Part 8: Sectional specification set for non-conductive films and coatings - Section 8: Temporary polymer coatings
Optical fibre cables - Part 1-211: Generic specification - Basic optical cable test procedures - Environmental test methods - Sheath shrinkage, method F11
Household and similar electrical appliances - Safety - Part 2-99: Particular requirements for commercial electric hoods
Electromechanical components for electronic equipment - Basic testing procedures and measuring methods - Part 1: General examination - Section 3: Test 1c - Electrical engagement length
Electric cables - Calculation of the current rating - Part 2-3: Thermal resistance - Cables installed in ventilated tunnels
Materials for printed boards and other interconnecting structures - Part 2-26: Reinforced base materials clad and unclad - Non-halogenated epoxide non-woven/woven E-glass reinforced laminated sheets of defined flammabil…
Lead-acid starter batteries - Part 7: General requirements and methods of test for motorcycle batteries
Pressure-sensitive adhesive tapes for electrical purposes - Part 3: Specifications for individual materials - Sheet 19: Tapes made from various backing materials with pressure-sensitive adhesive on both sides
Optical fibre cables - Part 1-308: Generic specification - Basic optical cable test procedures - Cable element test methods – Ribbon residual twist test, method G8
Maritime navigation and radiocommunication equipment and systems - Global navigation satellite systems (GNSS) - Part 4: Shipborne DGPS and DGLONASS maritime radio beacon receiver equipment - Performance requirements, me…
Connectors for electronic equipment - Tests and measurements - Part 27-100: Signal integrity tests up to 500 MHz on 60603-7 series connectors - Tests 27a to 27g
Safety requirements for electrical equipment for measurement, control, and laboratory use - Part 2-012: Particular requirements for climatic and environmental testing and other temperature conditioning equipment
Test procedure for the determination of the temperature index of enamelled and tape wrapped winding wires
Multicore and symmetrical pair/quad cables for digital communications - Part 13: Symmetrical single pair cables with transmission characteristics up to 20 MHz - Horizontal floor wiring - Sectional specification