This site uses cookies and visit counters for operation and statistics. Privacy policy
Found: 9 942
Power transformers - Part 22-7: Power transformer and reactor fittings - Accessories and fittings
Electric cables - Calculation of the current rating - Part 2-1: Thermal resistance - Calculation of thermal resistance
Household and similar electrical appliances - Safety - Part 2-66: Particular requirements for water-bed heaters
Connectors for frequencies below 3 MHz - Part 17: Detailspecification for interconnection devices which permit multi-directional mating, for use with rechargeable batteries
Specification for insulating materials based on mica - Part 2: Methods of test
Low-voltage switchgear and controlgear - Part 5-6: Control circuit devices and switching elements - DC interface for proximity sensors and switching amplifiers (NAMUR)
Coaxial communication cables - Part 5: Sectional specification for CATV trunk and distribution cables
Insulators for overhead lines with a nominal voltage above 1000 V - Part 1: Ceramic or glass insulator units for a.c. systems - Definitions, test methods and acceptance criteria
Pressure-sensitive adhesive tapes for electrical purposes - Part 3: Specifications for individual materials - Sheet 16: Polyester film/glass filament combinations with pressure-sensitive adhesive
Mechanical structures for electronic equipment - Dimensions of mechanical structures of the 482,6 mm (19 in) series - Part 3-104: Connector dependent interface dimensions of subracks and plug-in units
Radio-frequency connectors - Part 16: Sectional specification - RF coaxial connectors with inner diameter of outer conductor 7 mm (0,276 in) with screw coupling - Characteristics impedance 50 ohms (75 ohms) (type N)
Specifications for particular types of winding wires - Part 61: Polyester glass-fibre wound, resin or varnish impregnated, bare or enamelled rectangular copper wire, temperature index 180
Materials for interconnection structures - Part 8: Sectional specification set for non-conductive films and coatings - Section 8: Temporary polymer coatings
Optical fibre cables - Part 1-211: Generic specification - Basic optical cable test procedures - Environmental test methods - Sheath shrinkage, method F11
Household and similar electrical appliances - Safety - Part 2-99: Particular requirements for commercial electric hoods
Electromechanical components for electronic equipment - Basic testing procedures and measuring methods - Part 1: General examination - Section 3: Test 1c - Electrical engagement length
Electric cables - Calculation of the current rating - Part 2-3: Thermal resistance - Cables installed in ventilated tunnels
Materials for printed boards and other interconnecting structures - Part 2-26: Reinforced base materials clad and unclad - Non-halogenated epoxide non-woven/woven E-glass reinforced laminated sheets of defined flammabil…
Lead-acid starter batteries - Part 7: General requirements and methods of test for motorcycle batteries
Pressure-sensitive adhesive tapes for electrical purposes - Part 3: Specifications for individual materials - Sheet 19: Tapes made from various backing materials with pressure-sensitive adhesive on both sides