This site uses cookies and visit counters for operation and statistics. Privacy policy
Found: 11 444
Series capacitors for power systems - Thyristors controlled series capacitors
Copper and copper alloys. Plumbing fittings - Fittings with push-fit ends
Fibre optic connector optical interfaces - Optical interfaces for single mode non-dispersion shifted fibres. General and guidance
Pressure regulators for use with medical gases - Manifold and line pressure regulators
Fuel cell technologies - Stationary fuel cell power systems. Performance test methods
Measurement of radioactivity in the environment. Air: radon-222 - Spot measurement method of the activity concentration
Daylight in buildings
Banking. Nostro accounts reconciliation
Plastics piping systems for water supply, and for drainage and sewerage under pressure. Polyethylene (PE) - Fitness for purpose of the system
Fine ceramics (advanced ceramics, advanced technical ceramics). Test method for fracture resistance of monolithic ceramics at room temperature by indentation fracture (IF) method
Components for smoke and heat control systems - Specification for smoke curtains
Appliance couplers for household and similar general purposes - Appliance coupler with a degree of protection higher than IPX0
Tools for pressing. Guide pillars - Type B, end-locking pillars
Water quality. Radium-226 - Test method using liquid scintillation counting
Advanced technical ceramics. Monolithic ceramics. General and textural properties - Determination of grain size and size distribution (characterized by the linear intercept method)
Implants for surgery. Wear of total intervertebral spinal disc prostheses - Impingement-wear testing and corresponding environmental conditions for test of lumbar prostheses under adverse kinematic conditions
Highway parapets for bridges and other structures - Specification for vehicle containment parapets of metal construction
Specification for testing zinc coatings on steel wire and for quality requirements
Pulps. Laboratory wet disintegration - Disintegration of mechanical pulps at greater than or equal to 85 °C
Format for LSI-Package-Board interoperable design
