ISO 2132-1972 rus PDF

Full title and description

St ISO 2132-1972 rus — International Standard ISO 2132:1972, titled "Offset duplicators — Attachment features of plates". This entry refers to the original ISO document (first edition, 1972) and to commercially available Russian‑language renditions or translations of that text.

Abstract

Specifies a method for attaching offset duplicator plates to duplicating machines, including required hole diameters, spacing and position tolerances. The standard covers single‑edge and double‑edge punched plates and was issued as a one‑page technical specification with a later amendment.

General information

• Status: Withdrawn (ISO record shows the standard as withdrawn).
• Publication date: February 1972 (Edition 1, 1972-02).
• Publisher: ISO — International Organization for Standardization.
• ICS / categories: 37.100.10 (Reproduction equipment).
• Edition / version: Edition 1 (1972); includes Amendment 1 (1975) that modified a clause; both documents are noted as withdrawn.
• Number of pages: 1 (concise technical specification).

Scope

Defines the attachment features for offset duplicator plates: hole diameters, spacing and permissible position tolerances to ensure secure and repeatable mounting on duplicating machines. Applicable to plates with single‑edge or double‑edge punching; intended for use by manufacturers and technical personnel concerned with plate mounting and interchangeability.

Key topics and requirements

• Attachment geometry for offset duplicator plates (hole diameter and spacing requirements).
• Position tolerance limits for punched holes to ensure correct alignment on duplicating machines.
• Coverage of single‑edge and double‑edge punched plate formats.
• Short technical form (one‑page specification) with a small 1975 amendment clarifying clause text.

Typical use and users

Primary users were (and would be) duplicator and printing‑equipment manufacturers, plant engineering and maintenance teams, prepress technicians, standards librarians and organizations that preserved or reference historical technical specifications for reprographic equipment. Russian‑language copies are available from commercial standards resellers for users requiring the text in Russian.

Related standards

Contemporary ISO items addressing duplicators and stencil systems (for example ISO 2133 and other ISO documents in the 2000–2999 series dealing with reprographic equipment) are related by subject area; ISO 2132 itself was withdrawn and listed among early ISO standards for reproduction equipment.

Keywords

offset duplicators, plate attachment, plate punching, hole diameter, spacing tolerance, duplicator plates, reprographic equipment, ISO 2132, Russian translation

FAQ

Q: What is this standard?

A: ISO 2132:1972 is an international technical specification titled "Offset duplicators — Attachment features of plates", specifying plate mounting features for offset duplicators.

Q: What does it cover?

A: It covers the geometry and tolerances for holes used to attach offset duplicator plates (diameter, spacing and position tolerances), for both single‑edge and double‑edge punched plates.

Q: Who typically uses it?

A: Manufacturers of duplicating/printing equipment, prepress and maintenance personnel, and standards librarians or archivists; purchasers of historical or legacy standards may also obtain Russian translations from commercial resellers.

Q: Is it current or superseded?

A: ISO 2132:1972 has been withdrawn (the ISO record indicates withdrawal of the standard). It is treated as a historical/withdrawn document rather than a current active international standard.

Q: Is it part of a series?

A: It belongs to the family of ISO documents addressing reproduction and duplicating equipment (ICS 37.100.10); closely related standards dealing with duplicators and stencils appear in the same numeric range.

Q: What are the key keywords?

A: Offset duplicators, plate attachment, punched plates, hole spacing, position tolerance, reproduction equipment, ISO 2132.