ASTM D5746-24 PDF

SIGNIFICANCE AND USE 4.1 Uses—This classification is intended for use by federal landholding agencies and DoD components in order to direct ECOP efforts. It is also intended for use by preparers and reviewers of environmental condition of property maps, explosives safety condition maps, and ECOP reports used to support CERFA uncontaminated parcel identifications and parcels suitable for transfer by lease or by deed. This classification should be used to facilitate standardized determinations of the environmental condition and explosives safety conditions of a federal landholding agency, FUDS, and DoD installation's real property. Such environmental condition of property and explosives safety condition determinations are necessary to assess the progress of ongoing environmental restoration, identify areas where further response may be required, identify areas where further evaluation is necessary, and to support FOSTs and FOSLs. An environmental condition of property map, and explosives safety condition map, if applicable, based upon the ECOP report prepared in accordance with Practice D6008, is prepared using this classification. The ECOP report may be used to determine the MILCON category (see Section 8 and Table X1.1 in Appendix X1). SCOPE 1.1 Purpose—The purpose of this classification is to define eight standard environmental condition of property area types for federally-owned real property with respect to the requirements of the Comprehensive Environmental Response, Compensation and Liability Act (CERCLA) of 1980 Section 120(h), as amended by the Community Environmental Response Facilitation Act (CERFA) of 1992, and Section 331 of the National Defense Authorization Act for Fiscal Year 1997. As such, this classification is intended to permit a federal landholding agency to classify property into eight area types, in order to facilitate and support findings of suitability to transfer (FOSTs), findings of suitability to lease (FOSLs), and uncontaminated parcel determinations pursuant to the requirements of CERFA. Users of this classification should note that it does not address (except where noted explicitly) requirements for appropriate and timely regulatory consultation or concurrence, or both, during the identification and use of these environmental condition of property area types. 1.1.1 Eight Recognized Standard Environmental Condition of Property Area Types—The goal of this classification is to permit federal landholding agencies to classify properties in order to support determinations of which properties are suitable and unsuitable for transfer by lease or by deed. The term “standard environmental condition of property area type” refers to one of the eight area types defined in this classification. An identification of an area type on an environmental condition of property map means that a federal landholding agency federally-owned has conducted sufficient studies to make a determination of the recognized environmental conditions of installation real property or has complied with the identification requirements of uncontaminated property under CERFA, or both, and has categorized the property into one of the following eight area types: 1.1.1.1 Standard Environmental Condition of Property Area Type 1—An area or parcel of real property where no release, or disposal of hazardous substances or petroleum products or their derivatives has occurred (including no migration of these substances from adjoining properties). 1.1.1.2 Standard Environmental Condition of Property Area Type 2—An area or parcel of real property where only the release or disposal of petroleum products or their derivatives has occurred. 1.1.1.3 Standard Environmental Condition of Property Area Type 3—An area or parcel of real property where release, disposal, or migration, or some combination thereof, of hazardous substances has occurred, but at concentrations that do not require a removal or remedial action. 1.1.1.4 Standard E...