Tool chucks (end mill holders) with clamp screws for flatted cylindrical shank tools - Connecting dimensions of chucks and designation
Tool chucks (end mill holders) with clamp screws for flatted cylindrical shank tools - Connecting dimensions of chucks and designation
Мы хотим включить аналитику посещений, чтобы понимать, что искать людям на сайте. Без вашего согласия счётчики не загружаются. Политика конфиденциальности
1 Scope This part of ISO 5414 specifies the dimensions of tool chucks (end mill holders) with clamp screws for tools with flatted cylindrical shanks in accordance with ISO 3338-2. It also specifies the designations of these chucks. Two types of connection are defined:
— chucks with 7/24 taper shanks in accordance with ISO 297 for manual changers and with ISO 7388-1 for automatic changers, for tool shanks with either single flat or a double flat for manual and automatic changers;
NOTE 1 This part of ISO 5414 specifies the dimensions of tool chucks with 7/24 taper shanks No. 30 for automatic changers although these are not standardized.
— chucks with Morse taper shanks in accordance with ISO 296 and ISO 5413 for tool shanks with a single flat only.
NOTE 2 The dimensions of the driving system of the tool shanks are dealt with in ISO 5414-1.
Стандарты, упомянутые в описании