Overview
EN ISO 7539-3:1995 - Corrosion of metals and alloys - Stress corrosion testing - Part 3: Preparation and use of U-bend specimens (ISO 7539-3:1989) describes procedures for designing, preparing and using U‑bend specimens to assess susceptibility to stress corrosion cracking (SCC). The standard applies to a variety of product forms (sheet, plate, flat extruded material, wire, rod and welded parts) and complements general guidance in ISO 7539-1.
Key topics and technical requirements
- Test principle: expose a metal specimen bent into a U‑shape so that tensile stresses (up to yield point over part of the surface) are present, then monitor for crack initiation in a corrosive environment.
- Specimen forms: flat rectangular cross-sections are typical (sheet, plate, extrusions); circular cross-sections (wire, rod) and welded configurations may also be used.
- Forming and stressing: methods of forming and fastening are described; attention is required to restore and maintain the intended deflection after fastening. Two-stage and single-stage stressing arrangements are referenced.
- Surface condition: fine surface finish is recommended for laboratory screening (allows early crack detection); use representative plant finish for in‑service testing. ISO 7539-1 contains further guidance.
- Electrical isolation: when multiple metals are present, specimens should be electrically insulated to avoid galvanic effects.
- Safety warning: specimens from high‑strength materials may fracture rapidly and eject fragments - personnel must be warned and protected.
- Reproducibility and variability: results can vary widely even for nominally identical specimens; replication is often necessary. Stress levels cannot be quantified accurately with U‑bends - use alternative methods if precise stress measurement is required.
- Examination and reporting: periodic visual or low‑power microscopy inspections are used. Typical process‑plant exposure times cited include 5–10 weeks for in‑service screening. Test reports should document material composition and condition, specimen geometry and orientation, surface prep, test environment/location, observation times and time to first crack.
Practical applications and users
- Use cases: screening materials for SCC susceptibility, evaluating risk of failure in service environments, validating material choices for corrosive process conditions, and on‑site plant testing where simplicity and adaptability are priorities.
- Who uses it: corrosion engineers, materials scientists, failure analysts, quality assurance teams in oil & gas, chemical processing, power generation, and metallurgical labs.
Related standards
- ISO 7539-1 (general guidance on stress corrosion testing) - read in conjunction with Part 3.
- Other parts of ISO 7539 series cover bent-beam, C-ring, pre-cracked specimens, slow strain rate tests and welded specimens.
Keywords: EN ISO 7539-3:1995, U-bend specimens, stress corrosion testing, stress corrosion cracking, specimen preparation, corrosion testing standard.