Overview
ISO 4470:1981 is an international standard developed by the International Organization for Standardization (ISO) that specifies methods for determining the average moisture content of a lot of sawn timber. The moisture content of timber is a critical parameter affecting its quality, durability, and suitability for various applications. This standard outlines two practical and reliable methods of measurement: (a) using an electrical moisture meter and (b) the drying method involving mass loss determination. Both methods are designed to ensure consistent and accurate assessment of moisture content in homogeneous lots of sawn timber.
Key Topics
-
Scope and Applicability
- Suitable for homogeneous lots of sawn timber with the same cross-section.
- Electrical moisture meter method is applicable for timber moisture contents between 7% and 28%, excluding frozen timber.
- Drying method is applicable regardless of moisture content and is the preferred method in disputes due to its high accuracy.
-
Method 1: Electrical Moisture Meter
- Uses measurement of electrical resistance or conductance of test pieces.
- Requires a moisture meter calibrated for the wood species.
- Non-destructive, no need to cut test pieces.
- Sampling according to ISO 2859 with random selection.
- Measurement points on the timber faces must be free of dirt and defects.
- Multiple readings per test piece ensure measurement reliability.
- Results are expressed as average moisture content in percentage by mass.
-
Method 2: Drying Method
- Involves cutting test pieces and measuring weight loss upon drying.
- Requires precise weighing equipment and oven-drying at 103 ± 2°C until constant mass is achieved.
- Test pieces are weighed before and after drying and moisture content calculated based on mass difference.
- Suitable for all timber moisture contents and is the only method advised for legal or technical disputes.
- Sampling also follows ISO 2859 with a special inspection level.
-
Sampling and Test Preparation
- Samples are taken randomly according to specified inspection levels.
- Test pieces must be cut as full cross-section sections approximately 20 mm long.
- Pieces must be free of bark and visible defects to ensure accurate results.
-
Calculation and Reporting
- Moisture content expressed as a percentage by mass (nearest 1% for electrical method, nearest 0.1% for drying).
- Test reports must include method used, equipment details, test date, and individual and average results.
- Clear reference to ISO 4470:1981 is mandatory in documentation.
Applications
Related Standards
-
ISO 2859 – Sampling procedures and tables for inspection by attributes: This standard guides the random sampling process required both for electrical and drying moisture tests.
-
ISO 2780 – Wood preservatives - Determination of moisture content of treated wood: Addresses moisture testing specifically for treated wood with chemical preservatives.
-
ISO 5834 – Timber - Moisture content determination for different wood products and methods: Covers additional moisture measurement methods beyond ISO 4470.
Keywords: ISO 4470, sawn timber, moisture content, electrical moisture meter, drying method, timber quality control, wood moisture measurement, sampling procedures, ISO standards, timber testing methods