Electrical steel. Methods of measurement of the magnetostriction characteristics by means of single sheet and Epstein test specimens
Electrical steel. Methods of measurement of the magnetostriction characteristics by means of single sheet and Epstein test specimens
Мы хотим включить аналитику посещений, чтобы понимать, что искать людям на сайте. Без вашего согласия счётчики не загружаются. Политика конфиденциальности
PD IEC/TR 62581:2010 Electrical steel. Methods of measurement of the magnetostriction characteristics by means of single sheet and Epstein test specimens PD IEC/TR 62581 is a technical report which describes the general principles and technical details of the measurement of the magnetostriction of single sheet specimens preferably 500 mm long and 100 mm wide and Epstein strip specimens, specified in IEC 60404-2, of electrical steel by means of optical sensors and accelerometers. These methods are applicable to test specimens obtained from electrical steel sheets and strips of any grade. The characteristics of magnetostriction are determined for a sinusoidal induced voltage, for specified peak values of magnetic polarization and for a specified frequency. The measurements are made at an ambient temperature of 23 °C ± 5 °C on test specimens which have first been demagnetized. Contents of PD IEC/TR 62581: Foreword Introduction 1 Scope 2 Normative references 3 Terms and definitions 4 Method of measurement of the magnetostriction characteristics of electrical steel sheets under applied stress by means of a single sheet tester 4.1 Principle of the method 4.2 Test specimen 4.3 Yokes 4.4 Windings 4.5 Air flux compensation 4.6 Power supply 4.7 Optical sensor 4.8 Stressing device 4.9 Data acquisitions 4.10 Data processing 4.11 Preparation for measurement
Упомянутые в описании и другие стандарты PD